Origin Storage N8800+ & 8x3TB HDD User Manual download pdf (Page 155)

155

Replacing Damaged Hard Drives

If you are using RAID 1, RAID 5, or RAID 6 you can easily replace a damaged hard

drive in the Thecus IP storage while keeping your data secure with the system’s

automatic data recovery.

Hard Drive Damage

When a hard drive is damaged and data in the RAID volume, the system LCD will

display warning message also the system beeps.

Replacing a Hard Drive

To replace a hard disk drive in Thecus IP storage:

1. Remove the tray with the damaged hard disk (N3200XXX/N0503 is using

HDD rail).

2. Unscrew the damaged hard disk and remove it from the tray.

3. Slide a new hard disk into the tray and fasten the screws.

4. Insert the hard disk tray back into Thecus IP storage until it snaps into place.

You can also lock it with a key if desired.

5. The LED blinks green when the HDD is accessed.

RAID Auto-Rebuild

When using RAID 1, 5, 6, or 10 on Thecus IP storage, you can use the auto-rebuild

function when an error is detected.

1. When a hard disk fails the system beeps and/or an email notification is sent

to specified receivers.

2. Check the LCD to see which disk has failed.

3. Follow the steps mentioned above to replace the failed hard disk.

4. The system automatically recognizes the new hard disk and starts the

auto-rebuild sequence to resume its status before the hard disk crash.

1 2 ... 150 151 152 153 154 155 156 157 158 159 160 ... 167 168

Comments to this Manuals

No comments